Installation Instructions

Annexes Page 49/57
Installation and starting instructions
IX. Annexes
5) “Configuration & Installation” – “Reset Factory” menu [0831]
Press then and to open following screen.
« RESET FACTORY » menu will allow you to reset the regulator configuration by choosing some pre-set
operating options.
 Factory defaut setting
- Click on it to select the desired default setting:
o Custom (select sensors and outputs)
o Configuration 1 : CTFS conductivity Volume – Bio A - Inhibitor
o Configuration 2 : CTFS conductivity Volume – Bio A – Inhibitor - ORP
o Configuration 3 : CTFS conductivity Volume – Bio A – Inhibitor - Chlorine
o Configuration 4 : Volumetric mode Volume – Bio A – Inhibitor
o Configuration 5 : Resistive conductivity Volume – Bio A – Inhibitor
 Sensors list
- Select desired sensor configuration from predefined configuration:
o CTFS Sensor (SI1)
o Temperature Sensor (RI1)
o Conductivity Sensor (RI2)
o Volume counter (DI1)
o Flow-switch contact (DI2)
 Output list
- Select desired output configuration from predefined configuration:
FACTORY
RESET
Menu
SETUP
Factory reset
Factory default setting Custom
Sensor list
CTFS Sensor (SI1)
Output list
Temperature Sensor (RI1)
Conductivity Sensor (RI2)
Volume counter
(DI1)
Flow-switch contact (DI2)
Bleed valve (PO1)
Biocide A (FO1)
Biocide B (FO2)
Inhibitor (FO3)
Dispersant (FO4)