Programming Instructions

Programming screen « Setup menu » Page 39/78
General programming instructions
6) Menu « Setup menu » - « CONDITIONS & FUNCTIONS » [0631]
« CONDITIONS & FUNCTIONS » menu will allow you to access the configuration of the flow switch
conditions.
Press to open the following screen.
Selection of the contact(s) to be taken into account, for the control of the flow switch. “Multiple” selection,
press the contact you want to associate to this parameter. Here SI1 contact is selected.
a) Conditions
Contact selected.
Press to unselect the contact.
Contact not selected.
Press to select the contact
Contact not selectable.
b) Tower management
 Function Enabled
- Check the box to activate the "Tower management" function
The "Tower Management" function is disabled originally.
 Output command relay FO4
- Output command relay selection, on this selection button you can choose the relay that will command
the output.
Press to change it.
 Management mode Master Slave
- Choose the tower management mode associated with your controller.
Master or Slave.
 Input remote control / state
- Input remote control / state selection, on this selection button you can choose the input remote
control / state.
Press to change it
CONDITIONS &
FUNCTIONS
Conditions & Tower management
Conditions
DI1 DI2 DI3 DI4 DI5 SI1
SI1
DI2
DI1
Tower management
Contact(s) used as flow switch
Function Enabled
Output command play R01
Management mode
Master Slave
Input remote control None