Programming Instructions

Programming screen « Setup menu » Page 40/78
General programming instructions
7) Menu « Setup menu » - « COMMUNICATION » [0731]
See. Part 3 « DOC0486 - Notice COOLTOUCH Partie 3 - Communication (EN)».
8) Menu « Setup menu » - « RESET FACTORY » [0831]
« RESET FACTORY » menu will allow you to reset the regulator configuration by choosing some
pre-set operating options.
Press to open the following screen.
 Factory defaut setting
- Click on it to select the desired default setting:
o Custom (select sensors and outputs)
o Configuration 1 : CTFS conductivity Volume – Bio A - Inhibitor
o Configuration 2 : CTFS conductivity Volume – Bio A – Inhibitor - ORP
o Configuration 3 : CTFS conductivity Volume – Bio A – Inhibitor - Chlorine
o Configuration 4 : Volumetric mode Volume – Bio A – Inhibitor
o Configuration 5 : Resistive conductivity Volume – Bio A – Inhibitor
 Sensors list
- Select desired sensor configuration from predefined configuration:
o CTFS Sensor (SI1)
o Temperature Sensor (RI1)
o Conductivity Sensor (RI2)
o Volume counter (DI1)
o Flow-switch contact (DI2)
 Output list
- Select desired output configuration from predefined configuration:
o Biocide A (FO1)
o Biocide B (FO2)
o Inhibitor (FO3)
o Dispersant (FO4)
Bleed valve (PO1) is always selected.
COMMUNICATION
Reset
Factory
Factory reset
Factory default setting Custom
Sensor list
CTFS Sensor (SI1)
Output list
Temperature Sensor (RI1)
Conductivity Sensor (RI2)
Volume counter
(DI1)
Flow-switch contact (DI2)
Bleed valve (PO1)
Biocide A (FO1)
Biocide B (FO2)
Inhibitor (FO3)
Dispersant (FO4)