Programming Instructions

Programming screen « Setup menu » Page 71/78

General programming instructions

 Not used inputs

7) Menu « User » - « OUTPUTS TEST » [0711]

« OUTPUTS TEST » menu will allow you to control relays or 4…20mA outputs to set pumps.

Press to open following screen.

 PO1 Percent of bleed

- Output name and function affected, press to toggle ON/OFF the relay.

Each press reverses the state.

Relay output is inactive

Relay output is active

 AO1 Volume

- Output name and function affected, press to open the numeric keyboard and enter the desired value

Even unaffected outputs can be tested.

OUTPUTS TEST

PO1 Percent of bleed FO1 Percent of bleed

FO2 Percent of bleed FO3 Percent of bleed

FO4 Percent of bleed

RO1 Not used

AI2 0 mA

Not used

Channel

number

Raw value of the signal

Unit of channel concerned

AO1 Volume

0 0

AO2 Not used mA mA