Installation Instructions
General use Page 29/67
Installation and starting instructions
13) 4…20mA outputs connections (AO1 to AO4)
4…20mA outputs are used to send information to a building management system or to control a dosing
device via a 4…20mA signal. The analog outputs are generative and operate with an internal voltage of
12 VDC. The maximum load is 500Ω.
4…20mA outputs are fully configurable. You can assign any parameter (measured or calculated) in
regulation or data transfer mode.
► Use a 2-wire cable
► Remove the protective sheath
► Strip wires on 7mm
► Pass the cable through a cable gland
► Connect the two wires of the 4…20mA loop to + (13) and – (14)
► Tighten the cable gland to seal
► Use a 2-wire cable
► Remove the protective sheath
► Strip wires on 7mm
► Pass the cable through a cable gland
► Connect the two wires of the 4…20mA loop to + (27) and – (28)
► Tighten the cable gland to seal.
► Use a 2-wire cable
► Remove the protective sheath
► Strip wires on 7mm
► Pass the cable through a cable gland
► Connect the two wires of the 4…20mA loop to + (15) and – (16)
► Tighten the cable gland to seal.
► Use a 2-wire cable
► Remove the protective sheath
► Strip wires on 7mm
► Pass the cable through a cable gland
► Connect the two wires of the 4…20mA loop to + (29) and – (30)
► Tighten the cable gland to seal.
AO1
AO2
AO3
AO4