Installation Instructions

Safety and environmental instructions Page 7/24
Installation and commissioning instructions
II. Safety and environmental instructions
Please:
 Read this manual carefully before the unpacking, the installing or the commissioning of this
equipment
 Take into account all the hazards and of recommended precautionary measures
The failure to respect these procedures can result in serious injury to users or damaging the device.
1) Use of the equipment
The CAA320X/CAA330X series Free Chlorine sensors are designed to measure Free Chlorine in potable,
sanitary, swimming pool or process water in which the chlorine measurement must be controlled. They
are not selective and can be used to measure Brome or other forms of oxydants (Contact us). They are
particularly suitable for measuring chlorine generated by salt electrolysis (salt water) in the Copper/Gold
version and for pressure operation when the flow rate on the electrodes is perfectly controlled. They
are dependent on variation of flow, pH and stabilizer.
Any different use is considered non-compliant and should be prohibited. SYCLOPE Electronique
S.A.S. will under no circumstances assume the liability and damages resulting therefrom.
Any use of interfaces that do not comply with the technical specifications defined in this
manual should also be prohibited.
2) User obligations
The user undertakes not to allow its employees to work with the equipment described in this manual
unless they:
 Are aware of the fundamental instructions relating to work safety and prevention of accidents
 Are trained in the use of the device and its environment
 Have read and understood these instructions, warnings and manipulation rules.
3) Risk prevention
The installation and connection of the probes should be only performed by specialized
personnel and qualified for this task.
The installation must comply with the current safety standards and instructions!
Before powering on the probe, always turn of the power to the measuring and viewing device!
Never open the probe when it is powered on!
Maintenance operations and repairs should be only performed by trained and specialized
personnel!
Be sure to choose the location of the probe according to the environment!
Probe must no be installed in a hazardous environment.
Must be installed away from direct sunlight, water splashes or chemicals, in a dry, ventilated
area isolated from corrosive vapours. It can be installed in domestic or residential and
industrial premises.
All input/output connections are connected to very low safety voltages. Any other higher
voltage is prohibited and dangerous for the user and equipment.