User manual

29
6. Installation
• Firstdisconnectthemountingringandtheholdingringfromthesurveillancecamera.Forthis,releasethe
two small grub screws in the holding ring so that the mounting ring and the holding ring can be removed
from the surveillance camera.
• Markthecorrespondingpositionsthroughthethreeattachmentholesofthemountingringifyouneedto
drill any holes to attach the mounting ring.
 Youmustdrillasufcientlysized hole as well to pass throughthe connection cable for invisible and
sabotage-proof placement.
When drilling or tightening screws, ensure that no present cables or lines are damaged.
Select the mounting site so that it is protected from attempts to manipulate the surveillance
camera. The surveillance camera therefore should be installed at a minimum height of 2.5 m.
• Eitherguideouttheconnectioncablefromthesideofthemountingringorpushitthroughapresenthole
in the wall where you want to screw on the mounting ring.
Protect the plugs from dust and dirt, e.g. with a small plastic bag.
 Iftheconnectioncableistooshort(dependingonthewallthicknessormountingposition),you
needtouseasuitableconnectionbox.Thisconnectionboxmustbesuitableforbeingmounted
outdoors, depending on mounting site of the camera.
The cable connection for the video output or the power supply can then be placed in the connec-
tionbox;thisalsoappliestothehousingwiththecontrolleverinthesurveillancecameracable.
Place the cables so that they are protected from manipulation, e.g. in a cable duct or similar.
• Putthesurveillancecameraontothemountingringandthenpushontheholdingring.Alignthecamera
accordingly and tighten the three small grub screws in the holding ring so that the holding ring and the
camera are fastened at the mounting ring.