User manual

32
Thebenetofthemodernoperatingmodes"AHD","CVI"and"TVI"isthatyoucantransmithigh-resolution
videosignals(960p)viaapresentcoax-cablewiththem.Therefore,itissufcienttoreplaceoldsurveillance
camerasandDVRswithmoderndevices(with"AHD","CVI"or"TVI").Thedifcultinstallationofnewcables
isnotrequired.
Proceed as follows to select an operating mode:
 ReadtheoperatinginstructionsofyourDVRtocheckwhichoperatingmodeitsupports(only
conventional "CVBS" video signal, or a high-resolution signal according to the "AHD", "CVI" or
"TVI" standards).
 Dependingontheavailableoperatingmode,youmayneedtoactivateitrstintheOSDmenu
of your DVR.
Only when the operating mode of the DVR matches the operating mode of the surveillance
camera will a picture appear later as well.
• ConnectthesurveillancecameratotheexternalpowersupplyandyourDVRasdescribedinchapter7.
• SelectthecorrectinputontheDVR.
You may now see no picture or only interferences, such as stripes running through.
• Movethecontrolleverinoneofthefourdirectionsandholditthereforatleast5secondstoselectthe
desired operating mode.
"CVBS" Move control lever towards "R"
"AHD" Move control lever towards "UP"
"CVI" Move control lever towards "DOWN"
"TVI" Move control lever towards "L"
• Thesurveillancecamerawillswitchtheoperatingmodeaftertheendof5seconds.Releasethecontrol
lever.
• Thenewoperatingmodeisnowsaved.