User manual

25
6. Installation
• Thesurveillancecamerahasapre-installedwallholder.Itcanbeattachedinasuitableloca-
tion with four screws. Use suitable screws and dowels for the surface.
 Youmustdrillasufcientlysizedholeaswelltopassthroughtheconnectioncableforinvisible
and sabotage-proof placement.
When drilling or tightening screws, ensure that no wires or lines are damaged.
Select the assembly site so that it is protected from manipulation attempts at the sur-
veillance camera. The surveillance camera therefore should be installed at a minimum
height of 2.5 m.
• Eitherguidetheconnectioncableunderthewallholderonthesideorpushitthroughapre-
sent hole in the wall where you want to screw on the wall holder.
Protect the plugs from dust and dirt, e.g. with a small plastic bag.
If the connection cable is too short (depending on the wall thickness or mounting posi-
tion),youneedtouseasuitableconnectionbox.Thisconnectionboxmustbesuitable
for assembly in the outdoor area depending on assembly site of the camera.
The cable connection for the video output or the power supply can then be placed in
theconnectionbox;thisalsoappliestothehousingwiththecontrolleverinthesurveil-
lance camera cable.
Place the cables so that they are protected from manipulation, e.g. in a cable duct or
similar.