User manual

28
Proceed as follows to select an operating mode:
Read the operating instructions of your DVR to check which operating mode it sup-
ports (only conventional "CVBS" video signal, or a high-resolution signal according to
the "AHD", "CVI" or "TVI" standards).
 Dependingontheavailableoperatingmode,youmayneedtoactivateitrstinthe
OSD menu of your DVR.
Only when the operating mode of the DVR matches the operating mode of the surveil-
lance camera will a picture appear later as well.
• ConnectthesurveillancecameratotheexternalpowersupplyandyourDVRasdescribedin
chapter 7.
• SelectthecorrectinputontheDVR.
You may now see no picture or only interferences, such as stripes running through.
• Movethecontrolleverinoneofthefourdirectionsandholditthereforatleast5secondsto
select the desired operating mode.
"CVBS" Move control lever towards "R"
"AHD" Move control lever towards "UP"
"CVI" Move control lever towards "DOWN"
"TVI" Move control lever towards "L"
• Thesurveillancecamerawillswitchtheoperatingmodeaftertheendof5seconds.Release
the control lever.
• Thenewoperatingmodeisnowsaved.
Important!
If you want to choose another operating mode, you need to interrupt the power supply
for a few seconds for reasons of safety and then reconnect it.
Then proceed as described above to switch the operating mode again.