Instructions

K OR A

KEY ALARM

KEY-ALARM JUMPER

• Keypad Active Output (“K”) -- It switches to (-) ground for 10 seconds on each key touch. It can be used to turn

on light, CCTV camera, or buzzer to notify a guard. See Application Hints for more information.

• Alarm Output (“A”) -- It switches to (-) ground while Alarm occurs in order to trigger external alarm to give

notication at remote location.

14: DU OUT (Duress Output)

An NPN transistor open collector output with maximum power rating of 24V DC/100mA sink. It is equivalent to an N.O.

(Normally Open) terminal switching to (-) ground after the Duress Code is entered. Use it to trigger an alarm zone of

a security system, or turn on a buzzer to notify a guard.

15: (-) GND (Common Ground)

A grounding point of the keypad that is common to terminal 2.

16: DOOR SENS N.C. (Door Position Sensing Input -- Normally Close)

A Normally Closed (N.C.) sensing point referring to (-) ground, with the help of a normally closed magnetic contact

monitors the open or close status of the door. It initiates the following functions for the system. Connect it with jumper

to (-) Ground if not used.

• Door Auto Re-lock

The system immediately re-locks the door after it is re-closed before the end of the programmed time for output 1.

It prevents unwanted “tailgate” entry.

• Door Forced Open Warning

The keypad generates “door forced open” warning and alarm instantly once the door is forced to open without a

valid user Code, Card or egress button. The warning lasts as long as the time programmed (1-999 sec). It can be

stopped with an User Code or card for output 1 at anytime. See programming Location 80 for the details.

• Door Propped-up Warning

The keypad generates propped-up warning beeps (does not activates alarm output) while the door is left open

longer than the allowable time programmed. The warning will last as long as the door is open until re-closed. See

programming Location 81 for the details.

• Inter-lock Control

The inter-lock control output always goes to (-) while the door is open, which gives signal to disable the partner

keypad in an inter-lock system. See the Inter-lock terminal 18 description for more information.

• Door Opening Alarm

Door Opening Alarm is designed for the emergency door only. It is always given when the door is opened unless a

valid user code or card is used prior to the door is opened. See programming Location 91 for the details.