Instructions

15
10. OTHER FACILITIES
a) ON-BOARD LED INDICATORS
RED / GREEN (Right) It lights up in Green for Output 1 activation; and Red for Output 2 activation.
AMBER (Centre) It ashes in Standby. It shows the system status in synchronization with the beep tones.
The standby ashing can be OFF with programming. See Location 73 for the details.
RED / GREEN (Left) It lights up in Red while one of the outputs is inhibited. It is ashing during inhibition
paused.
It is the Wiegand LED for feedback indication. It lights up in Green.
b) PACIFIER TONES & THE LED SIGNALS
The buzzer and the amber LED indicator give following tones and signals respectively for system status:
STATUS TONES * AMBER LED
In Programming Mode ----- ON
Successful Key Entry 1 Beep 1 Flash
Successful Code / Card Entry 2 Beeps 2 Flashes
Unsuccessful Code / Card Entry 5 Beeps 5 Flashes
Power Up Delay Continuous Beeps Continuous Flashes
Output Relay Activation ** 1 Second Long Beep -----
In Standby *** ----- 1 Flash in 1 Second Interval
System Refreshing ----- Fast Flashes for 2.5 Minutes
Card or Code Already Stored in System 1 Long Beep -----
Keypad link-up with Decoder Failed Continuous 1 Beep/1 sec -----
Real -time-clock stopped after power failure Continuous 3 Fast Beeps/5 secs -----
* All Pacier Tones can be ON or OFF through the programming option at Location 71
** The Output Relay Activation beep can be selected through the programming option at Location 72
*** The Standby ashing can be ON or OFF through the programming option at Location 73
c) JUMPER FOR BACK-LIT SELECTION
Full Back-lit The keypad gives dim backlit in standby. It turns to full backlit
when a key button is pressed, then back to dim backlit 10
seconds after the last key button is pressed.
Auto Back-lit The backlit is OFF in standby. It turns to full backlit when a key
button is pressed, then back to OFF 10 seconds after the last key
button is pressed.
FULL AUTO
BACK-LIT JUMPER