Instructions

19
c) DIRECT ACCESS TO PROGRAMMING MODE WITH “DAP” CODE -- 2 8 2 8
In case the Master Code is forgotten, apply the following procedures precisely to set keypad into programming
mode with DAP code:
1. Switch OFF all the power for 1 minute to ensure that the keypad is fully discharged.
2. Switch ON power again. The keypad is in Power-up Mode for 1 minute. The buzzer gives continuous beeps and
the Status LED is ashing. This is the only time frame to accept the DAP code.
3. Press the Egress Button (the button connecting accross EG IN, (Terminal 9) and (-)GND, (Terminal 15) once to
enable the keypad for accepting DAP code. The power-up beep stops after the Egress Button is pressed.
4. Key in the DAP code 2828 and validate it with * * (or ). The Status LED is ON and the keypad is in
programming mode like using Master Code. It is ready to accept new programming data as long as you like until
exit programming mode.
EGRESS BUTTON
→
DAP CODE
→
VALIDATION
PRESS ONCE
2828 * *
5. To program a new Master Code to replace the old one. See “Record A Master Code” stated at “Location 01” for
the details.
The keypad will set itself to normal operation mode 1 minute after power-up if the Egress Button is not
pressed and the DAP code is not keyed in. To set keypad back to power-up mode, repeat procedures 1-4.
d) SYSTEM REFRESHING WITH “REFRESHING CODE” --- 9 9 9 9
The keypad can be refreshed by cleaning all the programmed old data and set it back to default values except the
Master Code.
REFRESHING CODE
→
VALIDATION
9999 #
Make sure that system refreshing is really required before entering the refreshing code.
Refreshing takes few minutes. The status LED (amber) keeps ashing during refreshing.
The keypad is back to its default value after refreshing. Re-program of the desired values are necessary.