Instructions
24
4) Inhibit All The User Codes & EM Cards for Output 1 (Disable Access Control Manually)
To enhance the security of the access control keypad, the owner can stop the keypad after ofce hour or while the
house is nobody inside. Once the Output 1 (for door lock control) is inhibited, all the User Codes / Cards for it become
invalid and those people holding the User Code or Card are refused. This function Starts / Stops in toggle with the
following code entry.
SUPER USER CODE
# 9
------ Door Lock Operation Inhibited, Start / Stop in Toggle
The door is locked during Output 1 inhibited and the “INHIBIT” LED (Red) is ON.
Inhibition applies to all User Codes and EM Cards for Output 1 only. Output 2 and output 3 are not affected.
15. COMMON USER CODES FOR OUTPUT 1, 2 & 3 --
Locations 03, 04, & 05
The Common User Codes 1, 2 and 3 are prepared for operating of the Output 1, 2 and 3 respectively as an enhance
code. The Common User Codes MUST work in the form of “Card + Common Code” to operate the outputs to increase
the security of the access control system. See Media 4 at Locations 10, 20 & 30 for more information.
Common User Code alone can NOT operate the Outputs directly.
LOCATIONS
→
COMMON USER CODE
→
VALIDATION
03 - 05
4 to 8 Digits
#
(1) (2) (3)
(1) LOCATIONS
03 -- Location Stores The Common User Code for Output 1
04 -- Location Stores The Common User Code for Output 2
05 -- Location Stores The Common User Code for Output 3
(2) COMMON USER CODES
• The Common User Code can be 4 to 8 digits.
• When a new Common User Code is keyed in and conrmed, the old one is replaced.
(3) VALIDATION
• Pressing # key to conrm code entry.
Example:
• Set a Common User Code “1 3 5 7” for Output 1 ---- 03 1357 #
• Deleted a Common User Code from memory: Key in the Location number and #. ---- 03 #