Instructions
25
16. USER CODES / CARDS FOR OUTPUT 1, 2 & 3 --
Locations 10, 20 & 30
Total 1,200 User Codes / Cards are available for controlling of the three outputs.
LOCATIONS
→
MEDIA
→
USER ID
→
CARD / USER CODE
→
VALIDATION
10 - 30 1 - 5 000 - 999
Card / User Code Entry
#
(1) (2) (3) (4) (5)
(1) LOCATIONS (User Groups)
10 – Group 1 – 1,000 User Codes / Cards for controlling Output 1
20 – Group 2 – 100 User Codes / Cards for controlling Output 2
30 – Group 3 – 100 User Codes / Cards for controlling Output 3
(2) MEDIA (Operation Media) - please also see page 16-17 for more information of their security level
1 – Cards Only – 125Khz Proximity EM Card
2 – User Codes Only – 4-8 Digits
3 – Cards + Secondary User Code(s) – See Note (a)
4 – Cards + Common User Code – See Note (b)
5 – Delete Cards / User Codes from the selected User ID – See Note (c)
0999 – Group Clearing. Clear all the User Codes & Cards of the selected User Group Location. Clearing takes
few seconds to a minute.
(3) USER ID (The IDs of The User Codes and Cards)
000 – 999 – 1,000 User IDs for the User Codes & Cards in User Group 1 (Output 1)
001 – 100 – 100 User IDs for the User Codes & Cards in User Group 2 (Output 2)
001 – 100 – 100 User IDs for the User Codes & Cards in User Group 3 (Output 3)
(4) CARD / USER CODE
Read EM Card or key in User Code into each assigned User ID.
(5) VALIDATION
Press the # key once. Two-beep conrms the entry.
The Secondary User Code is a user code putting after a card in programming. It can be a proprietary user
code for each user card or a code repeatedly used for a group of user cards as group user code (e.g. for a
group of staff working in the same department).
The Common User Codes for the Output 1, 2 & 3 have been programmed rst at Locations 03 04 & 05
respectively. It is not necessary to key in the code again in programming here and it will follow the card
automatically after the card is read.
Deletion of an User Code or Card (if the card was lost) can be done by keying-in its ID number For deleting
an existing cards, simply read the card once and conrm. It does not require the ID number. The Card
includes the combinations of (1) Card Only, (2) Card + Secondary User Code and (3) Card + Common User
Code.