Instructions

(2) DURESS CODE IDs

01 - 50 50 Duress Code IDs for The Output 1

01 - 10 10 Duress Code IDs for The Output 2

01 - 10 10 Duress Code IDs for The Output 3

0999 = Clear all the Duress Codes from the selected Location group.

Please see the programming example below for the details.

(3) THE DURESS CODES

50, 10 and 10 Duress Codes can be programmed for Output 1, 2 and 3 respectively. They are stored in their two-digit

Code ID box. When a new Code is put into the same Code ID box, the old code is replaced.

• The Duress Codes are 4-8 digits for Manual Mode code entry.

• The Duress Codes MUST be in the same digit length with the Master Code for Auto Mode code entry.

• Always set a Duress Code that is easy to remember in Panic Situation. Only one number different from the daily

used User Code is highly recommended.

• Example: User Code is 1 3 6 9, then 3 3 6 9 or 1 3 6 0 might be a good choice for the Duress Code.

• The Duress Code can also be used to replace the Secondary User Code or Common User Code in Card

reading for the Duress reporting.

(4) VALIDATION

Press # key once. Two-beep conrms the entry.

EXAMPLES:

Example 1: Set a “Duress Code” with the number of “3 3 6 9” for Output 1

41 01 3369 #

(a) (b) (c) (d)

(a) Duress Code for Output 1, (b) Duress Code ID, (c) The Duress Code, (e) Entry Conrmation

Example 2: Set a “Duress Code” with the number of “2 3 9 8 0” for Output 2

42 01 23980 #

(a) (b) (c) (d)

(a) Duress Code for Output 2, (b) Duress Code ID, (c) The Duress Code, (e) Entry Conrmation

Example 3: Delete an Output 1 “Duress Code” from Duress Code ID 01 in the memory

41 01 #

(a) (b) (c)

(a) Duress Code for Output 1, (b) The Duress Code ID, (c) Delete Conrmation