Instructions
37
(2) LOCK-UP OPTIONS
The Options are represented by the following Numbers. They are described below:
1 --- After 10 successive false Card/User Code trials, the keypad locks during 60 seconds.
-- (Default)
2 --- After 10 successive false Card/User Code trials, activates the Duress output to switch to (-) ground. The Duress
Output can be released with any user Code or Card in the User Group 1 or Super User Code.
5 - 10 --- Selection of after 5 to 10 successive Card/User Code trials, the keypad locks during 15 minutes. The
keypad can be reset to release the lock-up with the “Super User Code” in the following way.
Example: Release the lock-up --
SUPER USER CODE
#9
00 --- Disappearance of all the above lock-up securities.
(3) VALIDATION
Press # key once. Two-beep conrms the entry
23. USER CODE ENTRY MODE – AUTO OR MANUAL
-- Location 70
LOCATION
→
ENTRY MODES
→
VALIDATION
70 1 or 2 #
(1) (2) (3)
(1) LOCATION
Key in Location 70
(2) USER CODE ENTRY MODES
Two modes 1 and 2 are available for User Code entry options. The EM Card is always in Auto Entry Mode and is
not affected by the selection here.
1 --- Auto Entry Mode
Auto Entry Mode requires no pressing of the # key after code entry for code checking.
In the Auto Entry Mode, the User Codes MUST be set in the same digit length of the Master Code (For example,
if the Master Code is 5 digits, then all User Codes must be in 5 digits as well. All other User Codes not in 5 digits
become invalid). When the number of digits reaches, the system will check the User Code automatically. Good for
high trafc access control.
2 --- Manual Entry Mode – (Default)
Manual Entry Mode always requires the # key following the User Code for code checking. The User Codes can be
4-8 digits arbitrary and they are NOT required to be in the same digit length of the Master Code. Manual Entry
increases the level of security in code trial by the unauthorized people.
(3) VALIDATION
Press # key once. Two-beep conrms the entry