Instructions

(2) OPERATION MODES

0 – Keypad Mode (Default)

Keypad Mode sets the keypad for stand-alone operation to provide its available functions. It is compatible with the

auxiliary readers/keypads for multi-station expansion.

1 – Server Mode

Server Mode sets the keypad to compatible with both the decoder for split-decoded operation and the auxiliary

readers/keypads for multi-station expansion. A split decoded keypad system uses the keypad(s) for human interface

outside and the internal decoder for door lock control to prevent sabotage.

(3) VALIDATION

Press # key once. Two-beep conrms the entry

36. CLOSE PROGRAMMING MODE -- (* *)

Always close programming mode with * * to set system back to normal Operation after programming.

The button is equivalent to the * button in the keypad with bell button.

VALIDATION

* * ------------------------------- System is back to normal operation mode

37. PROGRAMMING MAKE SIMPLE – FOR GENERAL

USERS

The DK-2882 is a multi purpose keypad. It has many functions for user’s selection. For those general users taking the

keypad for door strike only, most of the features can be kept in their Default values. Only the User Codes / Cards and

a private Master Code are required to program.

The keypad accepts 1) Card only, 2) Code only, 3) Card + Code or 4) Card + Common User Code to operate its

outputs.

a) PROGRAMMING

• The button is equivalent to the * button in the keypad with bell button.

• Wait 1 minute until the end of power up delay, or keyin 12# to stop the power-up delay instantly and set the

keypad to normal operation.

1) Set System in Programming Mode with The Factory Set Master Code 0 0 0 0

0000 ** ---- 2 beeps, system is in Programming Mode