Instructions
9
7. SAFETY INSTRUCTIONS
Read the operating instructions carefully and especially observe the safety information. If you do
not follow the safety instructions and information on proper handling in this manual, we assume
no liability for any resulting personal injury or damage to property. Such cases will invalidate the
warranty/guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dangerous playing material
for children.
• Protect the appliance from extreme temperatures, direct sunlight, strong jolts, high humidity, moisture,
ammable gases, steam and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and protect it from any
accidental use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height can damage the
product.
• Also observe the safety and operating instructions of any other devices which are connected to the
product.
• Make sure the location for installation has no strong low frequency electro-magnetic wave. Especially in
the range of 100-200 Khz.
• If there is more than one keypads with the same operation frequency installed closely in the location,
make sure that they are at least 60 cm (2 ft) apart from each other to prevention interference.
• Do not apply power to the system while it is in installation.
• Check carefully all the wirings are correct before applying power to the system for testing.
• The code lock has an IP66 protection rating, meaning that it can be installed and used both indoors and
outdoors.
• The control unit (split decoder) must be installed and used in dry indoor areas.
• Make sure that the connection cable is not pinched or damaged by sharp edges.
• Always comply with the accident prevention regulations for electrical equipment when using the product
in commercial facilities.
• Consult an expert when in doubt about the operation, safety or connection of the appliance.
• Maintenance, modications and repairs must only be completed by a technician or an authorised repair
centre.
• If you have questions which remain unanswered by these operating instructions, contact our technical
support service or other technical personnel.