Instructions
36
RESET OUTPUT TIMER WITH SUPER USER CODE
The Output Timer can be RESET manually at anytime with the Super User Code that operates the desired output
before the end of the time.
Example:
Reset Output 1 Timer --
SUPER USER CODE
#1 ------------- Output 1 stops
Reset Output 2 Timer --
SUPER USER CODE
#2 ------------- Output 2 stops
Reset Output 3 Timer --
SUPER USER CODE
#3 ------------- Output 3 stops
20. SYSTEM REAL-TIME-CLOCK -- Location 55
This 24 hour real-time-clock provides the daily time base for starting and stopping the function of inhibition to relay
output 1 (mainly for electric door lock strike).
No real-time-clock setting is required if daily start-stop inhibition at Location 56 is not enabled.
LOCATIONS
→
CURRENT REAL TIME
→
VALIDATION
55 hh : mm #
(1)
HOURS MINUTES
(2)
(4)
(1) LOCATION
Key in Location 55
(2) CURRENT REAL TIME
hh : mm – The current time in Hour and Minute. The allowed time gure is 00:00 – 23:59
The time setting is based on 24 hours daily with the rst two digits for hours and the last two digits for minutes.
The time in second always starts at 0 0.
(3) VALIDATION
Press # key once.
Two-beep conrms the setting and the clock starts to count in 24 hour basis from the programmed current time.
Programming Examples:
• Set the current time of “10:30” (AM) to the keypad ---- 55 1030 #
• Set the current time of “6:45” (PM) to the keypad ------ 55 1845 #