Instructions
37
The real-time-clock stops after power failure, which makes the real-time inhibition loses its time base. It is
necessary to re-program the system’s real-time-clock unless the keypad is back up with UPS.
The keypad gives warning beeps of 3 fast beeps / 5 seconds continuously after power failure until the
real-time-clock is re-programmed.
No after “power failure warning beep” will be given if Location 56 is not programmed with Start/Stop
times.
Suggest to program the clock every 3-6 months to keep time accuracy; or when time deviation is found.
21. START & STOP TIMES FOR DAILY INHIBITION OF
OUTPUT 1 -- Location 56
Setting with start and stop times into the keypad, the real-time inhibition period for output 1 will recycle daily until the
time settings are cleared.
This function works with the real-time-clock. Set up the real-time at Location 55 is necessary.
For safety reason, the Egress Button is designed always valid. The door lock (controlled by output 1) can be opened
with it at anytime during inhibition.
LOCATIONS
→
START TIME
→
STOP TIME
→
VALIDATION
56 hh : mm hh : mm #
(1)
HOURS MINUTES
(2)
HOURS MINUTES
(3)
(4)
(1) LOCATION
Key in Location 56
(2) START TIME
hh : mm – Set the real-time inhibition starting time in Hour and Minute. The allowed time gure is 00:00 – 23:59
The starting time is based on 24 hours daily with the rst two digits for hours and the last two digits
for minutes. The time in second always starts at 0 0.
(3) STOP TIME
hh : mm – Set the real-time inhibition stopping time in Hour and Minute. The allowed time gure is 00:00 – 23:59
The stopping time is based on 24 hours daily with the rst two digits for hours and the last two
digits for minutes. The time in second always starts at 0 0.
(4) VALIDATION
Press # key once.
Two-beep conrms the setting.