Instructions

40
1 --- Auto Entry Mode
Auto Entry Mode requires no pressing of the # key after code entry for code checking.
In the Auto Entry Mode, the User Codes MUST be set in the same digit length of the Master Code (For
example, if the Master Code is 5 digits, then all User Codes must be in 5 digits as well. All other User Codes
not in 5 digits become invalid). When the number of digits reaches, the system will check the User Code
automatically. Good for high trafc access control.
2 --- Manual Entry Mode – (Default)
Manual Entry Mode always requires the # key following the User Code for code checking. The User Codes can
be 4-8 digits arbitrar] and they are NOT required to be in the same digit length of the Master Code. Manual
Entry increases the level of security in code trial by the unauthorized people.
(3) VALIDATION
Press # key once. Two-beep conrms the entry
24. PACIFIER TONES ON-OFF SELECTION -- Location 71
LOCATION
→
FUNCTION MODES
→
VALIDATION
71 1 or 0 #
(1) (2) (3)
(1) LOCATION
Key in Location 71
(2) FUNCTION MODES FOR PACIFIER TONES
Pacier Tone is the Beep Tones from the keypad, which include the tones of Successful Key entry (1 beep) and the
Unsuccessful User Code/Card entry (5 beeps).
The beeps for the Warning and the Power-up Delay do not belong to pacier tones and can not be OFF.
1 --- Pacier Tone ON – (Default)
All the Pacier Tones available from the keypad are enabled. They are the response tones indicating the
operation status of the keypad after a Card/User Code is entered.
0 --- Pacier Tone OFF
All the Pacier Tones are OFF. Good for place needs for a silent environment.
(3) VALIDATION
Press # key once. Two-beep conrms the entry