User manual

9. Basic functions

a) Switching On/Off

Brieypushthebutton" " (4) on the screen/DVR for 2 seconds to switch the screen/DVR on or off. With the screen/

DVR switched on, the small red power LED (3) to the left of the button lights up.

 TheLi-Ion-rechargeablebatteryinstalledinthescreen/DVRisusuallyatatrstcommissioning.Ifthe

screen/DVR cannot be switched on, operate it via the enclosed mains adapter; the rechargeable battery is

charged as well here. Observe chapter 8.

The radio camera cannot be switched on or off. It works permanently if the voltage/power supply is con-

nected.

After activation of the screen/DVR and commissioning of the radio camera, the screen of the radio camera should

appear after a few seconds. When the signal of a radio camera is received, the LED (5) will light up green.

Ifnoimageappears,theradiocameramustbetaughtintothescreen/DVRrst.Thisisspecicallythecasewhen

you separately purchase additional radio cameras (one is enclosed, up to 3 more can be ordered as accessories; you

can operate a total of 4 radio cameras on the screen/DVR).

b) Calling/leaving OSD menu

Brieypushthe"MENU"button(6).Thenthemainmenuisdisplayed.

ToleavetheOSDmenu,alsobrieypushthebutton"MENU"(6)(severaltimesifrequired,ifthescreen/DVRisina

submenu).

c) Activating/deactivating AV output

Use the button "AV" (8) to switch between playback of the AV-signal on the screen/DVR and the AV-output.

If the AV-output is activated, the screen/DVR LC-display goes out. Concurrent display on the LC display

and the AV output is not permitted.

Connect the AV output (14) to an analogue AV input of a screen or TV via the enclosed AV cable.

d) Setting the volume

The radio camera used does not have any microphone; therefore, setting of the volume via the control buttons

" " (increase volume) or " " (reduce volume) is irrelevant. The display shows the current volume with a bar display

when these buttons are pushed.

If you can hear noise from the speaker on the rear of the screen/DVR, reduce the volume to the lowest set

value.