User manual

64
e) Single/Quad/Auto Mode
Thescreen/DVRoffersdifferentdisplaymodesforthecameraimages.Toswitchbetweenthedisplaymodes,briey
push the button "QUAD" (7) several times.
Unused channels can be deactivated in the OSD menu (e.g. if you only operate two cameras at channels
1 and 2, channels 3 and 4 can be deactivated).
• Mode 1
The images of all 4 radio cameras are displayed at the same time and at the same size (Quad-View). This operating
mode is automatically active after activation of the screen/DVR.
• Mode 2
The image of radio camera/channel 1 is displayed. Use the control button " " or " " to manually switch to a
different radio camera.
• Mode 3
The image of radio camera/channel 1 is displayed in the left area of the LC display (large image); the images of the
other radio cameras appear smaller at the right edge.
Brieypushingthecontrolbutton" " or " " permits choosing which camera image (or which channel) is dis-
played in large.
Ifyoubrieypushthebutton"LOOP"(19),thescreen/DVRactivatestheautomaticchangeofthecameraimages
(channels). The display duration until the change can be set in the OSD menu. Push the button "LOOP" (19) again to
switch off automatic change again.
f) Starting/terminating recording manually
To permit a recording, either an MicroSD/MicroSDHC memory card must be inserted or a USB data carrier
must be connected. The corresponding memory type also must be selected in the OSD menu.
• Ifrequired,rstusethecontrolbuttons" " or " " to choose the radio camera from which you want to record
the image.
• Brieypushthe"REC"(18)buttontostartorstoptherecording.
When a recording is running, the display shows the icon " ".
During manual recording, do not push any button (e.g. calling the OSD menu), since this may terminate the
recording.
g) Reset
To reset the screen/DVR, push the recessed button "RESET" (16) e.g. with a toothpick. All settings are lost.