User manual

q) Function "Power saving mode"

Here you can set a time after which the LC display will switch off to save power. Furthermore, whether the LC display

will switch itself on when a movement is recognised in the recording area can be switched on/off.

 OnlytheLCdisplayisswitchedoff;monitoringorrecordingarenotinuenced.

• After calling the function, you can select from two settings with the control buttons " " or " ";brieypushthe

button"OK"(9)toconrm:

"Time Interval": Use the arrows " " or " " to set a time after which the LC display switches off automatically. This

function can also be switched off; then the LC display remains permanently activated.

"Wake up on Motion": The arrows " " or " " can be used to set whether the display is automatically activated

when the PIR sensor in a radio camera recognises a motion/heat change in the recording area.

• Save the selection with the button "OK" (9); then you will leave setting mode again. Cancel as usual with the

"MENU" (6) button.