User manual

79
15. Submenu "Alarm"
• Asdescribedinchapter10,brieypushthebutton"MENU"(6)tocalltheOSDmenu.Thenusethecontrolbuttons
" " or " "toselectthecorrespondingsubmenuandpushthebutton"OK"(9)toconrm.
• Use the control buttons " " or " "toselectthedesiredfunctionnow.Conrmtheselectionwith"OK"(9).
• ToreturntothepriormenuortoleavetheOSDmenu,brieypushthebutton"MENU"(6)(repeatedlyifnecessary).
a) Function "Motion detection"
If you switch on the alarm, the screen/DVR will output a sound signal when a change to the camera image has been
recognised.
The volume of the alarm sound signal can be set; see chapter 11. p).
• After calling the function with the button "OK" (9), you can switch the sound signal on or off with the control buttons " " or
" ".
• Save the selection with the button "OK" (9); then you will leave setting mode again.
 Toleavesettingmodewithoutsavingthesettings(cancel),brieypushthebutton"MENU"(6).Thedisplay
will switch back to the prior menu.
b) Function "PIR detection"
If you switch on the alarm, the screen/DVR will output a sound signal when the PIR sensor has recognised a heat
change in the recording area.
The volume of the alarm sound signal can be set; see chapter 11. p).
• After calling the function with the button "OK" (9), you can switch the sound signal on or off with the control buttons " " or
" ".
• Save the selection with the button "OK" (9); then you will leave setting mode again.
 Toleavesettingmodewithoutsavingthesettings(cancel),brieypushthebutton"MENU"(6).Thedisplay
will switch back to the prior menu.