Manualshelf

User manual

ManualsBrandsSYGONIX ManualsDoor & Window ProtectionCode lock type Surface-mount 12 Vdc IP65 + touchscreen
21222324252627282930
27
8. Programming
a) Starting/Terminating Programming Mode
• To start the programming mode, enter the master code twice in sequence
(basic setting ex works: „1234“).
MMMM MMMM
The left LED lights up yellow and the code lock emits 4 signal sounds. The
code lock is now in programming mode.
Example:
You may now programme user codes or make other settings.
• To terminate the programming mode, push the pound key (#).
Example:
The left LED is lit red again (regular operation).
• If no key is pushed, the programming mode is automatically shut down after
about 90 seconds for reasons of safety. The left LED lights up red again (regu-
lar operation).