User manual

9. Preliminary camera setting
a) Factory settings
Operatingmode:PIR(motiondetector) Imagemode:Multi-shotrecording1image
Imageresolution:12MP Video:10seconds(720p)
Time-out:30seconds Resolution:5MP
Timelapse:Start7:00pm,end07:00am(nextday)
Time-out:30seconds Resolution:12MP
Image mode: Multi-shot recording 1 image
b) Switch position PSET
Operatingmode:PIR(motiondetector) Imagemode:Multi-shotrecording3images
Time-out:30seconds Resolution:5MP
c) Inserting batteries and SD card, setting the time and date
• Install4typeC1.5Vbatteries.Observecorrectpolarity+/-asindicatednexttothebattery
compartment(11)(seechapter10.,sectiona)Batteryoperation).
• Set the TEST OFF CAM PSETswitch(19)toOFFbeforeinsertingorremovinganSDcard.
• Insert an SD card in the SD card slot SD CARD(23).Themaximumstoragecapacityofthe
SDcardmaynotexceed32GB.
• Set the TEST OFF CAM PSETswitch(19)toTEST to set the date and time. Press the M
button.TheLCdisplay(14)showsthehourandminutesand“I”and“T”beginashing.
• Press the OKbutton.Pressthe▲(up)/▼(down)buttonstosetrstthehoursandthen
theminutes.Conrmeachsettingbypressingthe OK button before moving on the next
parameter.
• Thedisplaythenswitchestothedatesettingparameter.OntheLCdisplayshows“D”.
• Settheday,monthandyearwiththe▲/▼buttons.Conrmeachsettingbypressingthe
OK button.
42