User manual

a) Test LED function

Warning

NeverpointthecamerawiththetestLEDatyourselforotherpersonsoranimals

whenthefunctionisactive.AlwaysobservetheLEDinformationinthesection

“Safetyinstructions”.

• ThetestLED(4)canbeusedtotesttherangeofthePIRmotiondetectorandasacountdown

indicatorafterthecamerahasbeenactivated.

• Set the TEST OFF CAM PSET switch to CAMtoactivatethecamera.

• Afterapprox.30secondsoncethecamerahasbeenenabledforrecording,theLEDbegins

ashingforapprox.60seconds.Leavethedetectionareawithin60seconds.Thecamera

isnowactive.

b) PSET image mode

• Set the TEST OFF CAM PSET switch to PSET. This setting

bypasses all user settings and uses the following presets:

PIRmode/imagerecording/resolution:5MP/multishot

mode:3images(3P)/time-out:30seconds.

• If you select the preset PSET,thecameraoperatesinPIR

modeonly.Timelapsemode(TLS)willnotwork.

c) Setting image or video recording

• Set the TEST OFF CAM PSET switch to TEST. With this

setting the camera will be programmed.

• The LC display shows the current status. Press the M

button and then press ▼. The LC display ashes the

programminglevel“2”,“CAM”and“VIDEO”.