User manual

• Removeanybranchesandshrubberyinfrontofthecamerathatmightobstructtheimage.

Also remember that wind may blow shrubbery into the detection range and that high

temperatures may affect image quality.

• Check the batteries before turning on the camera.

• Make sure that an SD card is inserted before the camera is turned on.

• Makesurethatthecameraisintheoperatingmode“CAM”or“PSET”,notintestmode,

beforeyouleavethearea.

• Check that the time and date are set correctly.

• Makesurethatthecaseisclosedproperlytopreventwaterfromenteringthecamera.

• Pleasenotethatapprox.10secondsafterturningonthecamera,thetestLEDashesfor

approx.60seconds.Leavethedetectionareawithin60secondstopreventinadvertently

activatingthecamera.

a) Fastening the camera

• Fasten the camera to a tree, a wallor another xedobject using thesupplied fastening

strap(24)ortheincludedwallbracket(26).

• Thecameracanbescrewedontothewallbracketattachment(9)onthewallbracket.

• Pre-drillcorrespondingholesinthesurfacetofastenthewallbrackettoawall.Ifnecessary,

youcanusetheprovidedscrewsandwallanchorstofastenthewallbracket.

• Select an appropriate mounting surface.

• Highlight the position of the mounting holes on the mounting surface using a pencil or the like.

Use the wall bracket as a template.

• Drill the four mounting holes in the surface.

 Whendrillingholesandtighteningthescrews,makesurenottodamageanypower

lines or gas or water pipes below the surface.

• Screw the product to the surface.

• Loosenthesetscrewoftheballjointtoswivelandtiltthehousinginthedesiredposition.Lock

the position by re-tightening the set screw.

• Attachthecamerawiththebatterycompartmentcoveralwaysontoptopreventwaterfrom

entering the control panel and LC display.