User manual
52
You may now programme the next day if desired (for the copy
function, see chapter 9. d).
Use the button “MENU” to return to the respective previous
programming step if desired.
Note:
Incorrect programming of times is automatically preven-
ted so that the switching processes are not confused.
If you have, e.g., set a temperature of 20.0 °C from 06:00
AM onwards in memory slot “P1” and a temperature of
18.0 °C from 9:00 AM onwards in memory slot “P2”, the
memory slot
“P3” cannot be programmed to any time
before 09:10 AM.
c) Function G3 “PROGRAM SETBACK”
If you want to change the temperature value of all programmes,
e.g., by 1 °C, you do not need to change the entire programming.
You only need to set a correction value (-3.0 °C......+3.0 °C) in the
function G3 “PROGRAM SETBACK”.
If you then check your temperatures in function G2 “PROGRAM
SETTING”, the value corrected accordingly is displayed there.
Example:
In programme “P1”, the time set is 06:00 AM and the temperature
value is 20.0 °C.
After programming “-1.0 °C” in the function “PROGRAM SETBACK”,
the temperature value in programme “P1” is now 19.0 °C.
If you set “0.0 °C” again in the function”PROGRAM SETBACK”, the
programme “P1” sets a temperature of 20.0 °C again.
Proceed as follows:
1. After selecting this function G3 “PROGRAM SETBACK” and
conrming with “OK” (2), the temperature correction value
ashes in the display.
2. Set the correction value (-3.0 °C......+3.0 °C).with the buttons
“–” (5) and “+” (6).