User manual

22
• Please note the dimensions in Fig. 1 and use the wall mount to draw two drill holes on the wall. Drill two holes in the
wall. Note the length of the dowel as well as the above dimensions.
• Insert dowels. If necessary, use a hammer. Attach the wall mount with long screws. Tighten the screws with a
Phillips screwdriver (Fig. 2).
• Hangthedeviceonthewallbracket.Drawtwoboreholesthroughthelowerwallbrackets(Fig.3).Removethe
product from the wall bracket.
• Drill the holes for the bottom wall bracket and insert the appropriate dowels (Fig. 4).
• Hang the appliance on the top wall bracket. Secure the device with two screws at the bottom wall brackets. Use a
Phillips screwdriver.
c) Installation in the bathroom
• It is recommended to install the device
with a minimum distance of 0.6 m from
showers or bath tubs for bathroom
installation. Always observe the statutory
regulations.Consultaqualiedelectrician
for more information.
9. Operation
Before you connect the mains plug to the mains socket, ensure that the device is switched off and the on/off switch (15)
is at position O.Connectthemainsplugtoamainssocket.
a) Automatic operation
• Turn on the device with the on/off switch on position I. The indicator light on the on/off switch lights up and (9)
appearsonthefunctiondisplay(13).Thetemperaturedisplay(10)ashesthepre-settemperatureof25°C for a
few seconds. After that, the room temperature is shown on the display.
• If the room temperature is above 25 °C,thedevicewillnotheatup.Iftheroomtemperatureisbelow25°C,the
unitautomaticallybeginstoheatup.Thedeviceheatsupasefcientlyaspossible.Withatemperaturedifference
of 1 °C,onlythelowestheatinglevelIisenabled.Withatemperaturedifferenceof2to3°C,onlyheatinglevelIIis
enabled. With a temperature difference of more than 4 °C,bothheatinglevels(IandII)areenabled.