User manual
General safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information
on proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the warranty/
guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may become
dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, ammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed
if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Before connecting the appliance to the power supply, check that the power supply
voltage and current rating corresponds with the power supply details shown on
the appliance rating label.
• Never pour any liquids over electrical devices or put objects lled with liquid
right next to the device. If liquid or an object enters the interior of the device
nevertheless, rst power down the respective socket (e.g. switch off circuit
breaker) and then pull the mains plug from the mains socket. Do not operate the
product anymore afterwards, but take it to a specialist workshop.
• Never use the product immediately after it has been brought from a cold room
into a warm one. The condensation generated could destroy the product. Allow
the device to reach room temperature before connecting and using it. This may
take several hours.
• The mains outlet must be located near to the device and be easily accessible.
• Always lay the cables so that nobody can trip over or become entangled in them.
This poses a risk of injury.
• When setting up the product, make sure that the cables are not pinched, kinked
or damaged by sharp edges.
• Never pull the mains plug from the socket by pulling at the cable. Always pull it
from the mains socket using the intended grips.
• Unplug the mains plug from the mains socket if you do not use the device for an
extended period of time.
• For safety reasons, always unplug the device in case of a thunderstorm.
• Make sure that the mains cable is not squeezed, bent, damaged by sharp edges
or put under mechanical stress. Avoid excessive thermal stress on the mains
cable from extreme heat or cold. Do not modify the mains cable. Otherwise the
mains cable may be damaged. A damaged mains cable can cause a deadly
electric shock.
• Do not touch the mains cable if it is damaged. First, power down the respective
mains socket (e.g. via the respective circuit breaker) and then carefully pull the
mains plug from the mains socket. Never use the product if the mains cable is
damaged.
• To prevent risks, damaged power cables may only be replaced by the manufacturer,
a professional workshop appointed by the manufacturer, or a similarly qualied
person.
• Never plug in or unplug the mains plug when your hands are wet.
• Carry the product only by its handle.
• Do not place any objects on the product; do not cover the product.
• Do not block any ventilation slots on the device, in order to ensure proper cooling.
• Do not insert objects or ngers into the device.
• Never leave the product unattended during use.
• Do not point the air outlet at people or pets.
• Never cover the air outlet.
• Keep the product away from heat sources.
• Do not use the product near inammable materials.
• Do not sit or stand on the product.
• Do not operate the device inside a cupboard. Otherwise there is a risk of re!
• Consult an expert when in doubt about operation, safety or connection of the
device.
• Maintenance, modications and repairs are to be performed exclusively by an
expert or at a qualied shop.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
Operating instructions
Dehumidier 410 W, 22 L
Item no. 1456298
Intended use
65 % humidity is the upper limit for humans to still feel comfortable. Humidity stands in a
certain relation to temperature. 35 - 65 % relative humidity at 21 °C are considered ideal for
well‑being. The dehumidier is used for dehumidifying air in privately used rooms (e.g. living
rooms, bedrooms, storage rooms or basements). Any other use is not intended.
The dehumidier monitors the relative humidity of the absorbed ambient air. When in contact
with the cooling elements, the humidity condenses as water and is discharged into the water
tank. The dry air gets heated up slightly before being released back into the room. Using the
carbon lter will lter odors, oil and other hydrocarbons from the air.
The product is not intended for commercial or industrial use. Using the product in business
establishments, workshops or industrial companies, or for any similar applications will void
the warranty.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in
bathrooms, must be avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use
the product for purposes other than those described above, the product may be damaged.
In addition, improper use can cause hazards such as short circuiting, re, electric shock etc.
Read the instructions carefully and keep them. Make this product available to third parties only
together with its operating instructions.
This product complies with the statutory national and European requirements. All company
names and product names are trademarks of their respective owners. All rights reserved.
Delivery content
• Dehumidier
• Carbon lter
• Operating instructions
Up-to-date operating instructions
Download the latest operating instructions from our website www.conrad.com/downloads or
scan the printed QR code. Follow the instructions on the website.
Description of symbols
The symbol with a ash in a triangle indicates health risks e.g. due to electric shock.
The symbol with an exclamation mark in a triangle indicates important instructions
contained in these operating instructions that must be followed.
The "arrow" symbol alerts the user to the presence of important tips and notes on
using the device.
Important safety instructions
• This device is not intended to be used by persons
(including children) with reduced physical, sensory
or mental abilities or lack of experience and / or
lack of knowledge unless they are supervised by a
person responsible for their safety or have received
instructions on how to use the device.
• Children should be supervised to ensure that they do
not play with the device.
• Important! Allow the product to stand for at least
2 hours before putting it into operation for the rst time
or after it has been moved, in order for the cooling
agent to settle in the compressor.