User manual

- If you attempt to add a sensor a second
time, the instructions window does not
close. Touch Cancel to close, then < to
reach the landing page.
7. Wait for the conrmation window, then touch
OK.
8. You will be asked to name the sensor. Enter
a name and conrm.
- If a sensor device comprises more than
one sensor, you will be asked to name
each sensor.
9. Touch < to return to the gateway page.
10. The sensor is added to the sensor list.
- A device may be a multiple-in-one sensor.
For such cases, multiple sensors are
added to the sensor device list.
- By default, newly added sensors are
disabled in the alert mode. Go to chapter
Enabling/Disabling A Sensor to learn how
to enable/disable and congure a sensor.
Add sensor via Gateway
1. Insert batteries into the sensor to power it
on.
2. Hold down the touch button on the gateway
(approx. 5 seconds) until the green indicator
light ashes and the pairing sound plays.
3. Press the pairing button at the sensor.
Observe the conrmation sound.
- If you wish to cancel the pairing process,
touch the touch button on the gateway.
4. The sensor is added to the gateway.