User manual
40
e) Changing the bell tone
The bell tone can be changed if the video door intercom system is in standby mode. It does not work while
talking to one of the outdoor units.
• Push the button “ ” (3) to play the current bell tone.
• Use the button “ ” (4) to select one of 4 different bell tones.
• Conrmtheselectedbelltonewiththebutton“ ” (3).
f) Changing settings for the colour display
The setting menu can only be called if the colour display is showing an image. For this, e.g. push the button
“ ” (4).
• If the display of the indoor unit shows the camera image, push the button “ ” (6), to call the setting menu.
• Use the button “ ” (6) to switch between
“Brightness”: Setting the brightness
“Contrast”: Setting the contrast
“Color”: Setting colour saturation
“Exit”: Leaves the setting menu
The current selection is marked in colour in each case.
• If “Brightness“, “Contrast” or “Color” is selected, you can change the settings with the buttons “ ” (7) or “ ” (8).
If “Exit” is selected and you push the button “ ” (7) or “ ” (8), you will leave the setting menu.
The setting menu is also left automatically if no button is pushed for a few seconds.
g) Activating/deactivating muting
Activating/deactivating muting is only possible if the video door intercom system is in standby mode. It does
not work while talking to one of the outdoor units.
With muting active, the indoor unit will not play the bell tone. Muting can be used, e.g. at night, when you
do not want to be disturbed.
• Push the button “ ” (5) to activate muting.
AredLEDashesinthebutton“ “.
• To deactivate muting again, push the button “ ” (5) again. The red LED goes out.
h) Setting the volume
• The playback volume at the indoor unit can be set with the controller (9).
• The playback volume at the outdoor unit can be set with the dial switch (22) (turn to the left counter-clockwise =
volume down, turn to the right clockwise = volume up).
• The dial switch (23) can be used to set the microphone sensitivity and thus indirectly the volume on the indoor unit
(turn to the left counter-clockwise = reduce sensitivity, turn to the right clockwise = increase sensitivity).