User manual

17.6 Installation
Danger of injury: When you screw or drill, make sure that no cable or pipes are damaged.
Keep a safe distance to the product when it is triggered to avoid damage to hearing. When the siren
sounds, approach it only with hearing protection.
Strictly follow the given installation procedure.
1. Study the installation diagrams in this chapter before you start the installation process.
2. Mark the mounting location through the two holes (3) in the lower and upper housing (see 1 ).
3. Drill holes and install wall plugs if necessary.
4. Remove the two screws on the rear of the siren (see 2 ).
5. Carefully remove the upper housing.
6. Connect a high quality 9 V battery (8) to the battery connector (see 3 ).
7. Arrange the battery inside the upper housing as indicated on the inside of the housing.
8. Replace the upper housing (see 4 ), turn the siren round and replace the two screws.
9. Connect the power supply cable (4) to the power adapter cable (see 5 ).
10. Completely unwind the power adapter cable and connect the wall plug transformer to a suitable mains outlet.
11. Put on hearing protection.
12. Hold down the tamper switch (6).
13. Refer to the corresponding app manual and pair the siren with the mobile app. You will make use of the pairing
button (5) for pairing.
Once the siren is paired and you release the tamper switch it immediately sounds. Temporarily dis-
able the alarm by holding down the tamper switch for 3 seconds. If you release the switch the siren
sounds again.
14. Align the siren with the mounting holes and press the siren against the installation surface. The tamper switch will
be pushed in, which automatically stops the alarm. If you remove the siren, the alarm sounds again.
15. Screw the siren in place (see 6 ).
34