User manual
15.5 Install batteries
• If an insulation strip is visible after unpacking the sensor, pull the strip to activate the batteries. In this case battery
installation is not necessary.
• AA/AAA batteries: When inserting batteries, observe the polarity indications inside the battery compartment if avail-
able.
• If the sensor no longer reacts, replace the batteries.
1 2 3
15.6 Placement
• The water leak sensor is protected against splash water from the top and can be used in bathrooms.
• Do not immerse the sensor in water.
• Only the metal pins on the underside of the sensor may sit in water.
28