Instructions
• In schools, training facilities, hobby or self-service workshops, handling of
electrical devices must be monitored by trained personnel.
• When operating on commercial premises, the relevant accident prevention
regulations of workers’ compensation boards for electrical equipment must be
observed.
• Always lay the cables so that nobody can trip over or become entangled in them.
This poses a risk of injury.
• Always check the product for damage before use. If you discover any damage, do
not use the product. Disconnect the power supply and unplug the mains plug from
the wall outlet. Then bring the product to a specialised workshop.
• Use only a proper mains socket (230 V/AC, 50Hz) connected to the public power
supply.
• Do not pull the mains plug out of the wall outlet by its cable!
• The plug must be pulled out of the socket under the following conditions:
- before cleaning the product
- during a thunder storm
- if the product is not being used over a long period.
• The mains outlet must be located near to the device and be easily accessible.
• When setting up the product, make sure that the cable is not pinched, kinked or
damaged by sharp edges.
• The product should not be used immediately after it has been brought from an
area of cold temperature to an area of warm temperature. Condensed water might
destroy the product. Wait until the product adapts to the new ambient temperature
before use.
• The outlet strip is equipped with a child safety device. Only when the prongs of
a power plug are inserted in both openings of a socket at the same time, will the
mechanism release the opening. Even so, be especially careful if children are
around. Children cannot understand the danger arising from the incorrect use of
electrical devices. There is a risk of a life-threatening electric shock!
• Never plug in or unplug the plug-in power unit with damp or wet hands. There is a
risk of a life-threatening electric shock!
• Do not cascade the outlet strip. Observe the connected load in the chapter
“Technical Data”.
• Do not connect in series! This can lead to overloading of the outlet strip! Fire
hazard! Plug the Schuko mains plug of the outlet strip directly into a wall outlet, for
example. Do not connect one outlet strip to another.
• Do not operate while covered! At higher connected loads, the outlet strip becomes
warm and the connection cable may lead to overheating and re, if covered!
• Current-free only when the plug is withdrawn!
• Consult an expert when in doubt about operation, safety or connection of the
device.
• Maintenance, modications and repairs are to be performed exclusively by an
expert or at a qualied shop.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
b) Battery
• Correct polarity must be observed while inserting the battery.
• The battery should be removed from the device if it is not used for a long period of
time to avoid damage through leaking. Leaking or damaged batteries might cause
acid burns when in contact with skin, therefore use suitable protective gloves to
handle corrupted batteries.
• Batteries must be kept out of reach of children. Do not leave batteries lying
around, as there is risk, that children or pets swallow them.
• Batteries must not be dismantled, short-circuited or thrown into re. Never
recharge non-rechargeable batteries. There is a risk of explosion!
Battery insertion / replacement
Remove the insulator strip before rst use.
1. Remove the battery compartment cover carefully, use a slot-head screwdriver to assist if
necessary.
2. Insert / replace a new battery of the same type (CR2032), while observing the correct
polarity, with the positive side facing upwards.
3. Replace the battery compartment cover.
Mounting
Only mount the product on a stable surface.
• Two hanging holes are provided at the back of the outlet strip. The product can be mounted
on a wall with proper screws. Make sure the screws are rmly xed on the wall.
• The foot switch can be attached to the oor, wall or other surface with the adhesive tape at
the back.
Operating instructions
Remote control outlet strip with foot switch
Item no. 1732605
Intended use
The product is intended for providing two continuous power outlets and four switchable power
outlets. The four switchable outlets can be remotely controlled with the foot switch. The outlet
strip must be connected to an earthed mains socket; the mains voltage must be 230 V/AC,
50 Hz. The total power consumption of all connected loads must not exceed 3680 W.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in
bathrooms, must be avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use
the product for purposes other than those described above, the product may be damaged.
In addition, improper use can cause hazards such as short circuiting, re, electric shock etc.
Read the instructions carefully and keep them. Make this product available to third parties only
together with its operating instructions.
This product complies with the statutory national and European requirements. All company
names and product names are trademarks of their respective owners. All rights reserved.
Delivery content
• Outlet strip
• Foot switch including battery (type CR2032)
• Operating instructions
Latest operating instructions
Download the latest operating instructions via the link www.conrad.com/downloads or scan the
QR code shown. Follow the instructions on the website.
Explanation of symbols
The lightning symbol inside a triangle is used when there is a potential risk of
personal injury, such as electric shock.
An exclamation mark in a triangle indicates important instructions in this operating
manual that absolutely have to be observed.
The arrow symbol indicates specic tips and advice on operation.
Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information
on proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the warranty/
guarantee.
a) General
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become
dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, ammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed
if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Also observe the safety and operating instructions of any other devices which are
connected to the product.
• Products operated using the mains voltage must be kept out of the reach of
children. For this reason, be particularly careful when using the product in the
presence of children. They may try to stick objects into the device through
openings in the housing. This poses a risk of death by electric shock.
• Never pour liquids over electrical appliances and never leave objects lled
with liquids (e.g. vases) on it or in the vicinity. There is a high risk of re or
life-threatening electric shock.
• Operate the product in dry interior spaces only. It must not get damp or wet.
Otherwise there is a risk of a life-threatening electric shock!