Instructions
Intended Use
This 2-channel wireless wall switch is designed to turn on and off two
appropriate receivers (e.g. wireless power socket, wireless outdoor
socket, wireless inbuilt switch etc.). In addition, this 2-channel wireless
wall switch has a dimming function (for example, to control a wireless
plug-in dimmer, wireless inbuilt dimmer etc.).
For each control channel, a maximum of 10 receivers can be pro-
grammed.
The wireless wall switch is powered by a 12 V battery (type: 23A).
It is intended for indoor use only. Do not use it outdoors. Contact with
moisture, e.g. in bathrooms, must be avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify
this product. If you use the product for purposes other than those
described above, the product may be damaged. In addition, improper
use can result in short circuits, res, electric shocks or other hazards.
Read the instructions carefully and store them in a safe place. Make
this product available to third parties only together with its operating
instructions.
This product complies with the statutory national and European
requirements. All company names and product names are trademarks
of their respective owners. All rights reserved.
Safety Instructions
Read the operating instructions carefully and
especially observe the safety information. If you do
not follow the safety instructions and information on
proper handling in this manual, we assume no liability
for any resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
a) General
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may
become dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight,
strong jolts, high humidity, moisture, ammable gases, vapours and
solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of
operation and protect it from any accidental use. Safe operation can
no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions
or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even
from a low height can damage the product.
• Check the product for damage before each use! If you notice any
damage, do not use the product any longer! There is a risk of a
life-threatening electric shock!
• Ensure that the insulation for the entire product is neither damaged
nor destroyed. Never disassemble the product! There are no ser-
viceable parts inside.
• Do not use this product in hospitals or medical institutions. Although
the product emits only relatively weak radio signals, these may lead
to the malfunction of life-support systems. The same may also be
the case in other areas.
• Keep the product away from strong magnetic elds generated by
machines, electric motors or loudspeakers.
• Consult an expert when in doubt about operation, safety or connec-
tion of the device.
• Maintenance, modications and repairs are to be performed exclu-
sively by an expert or at a qualied shop.
• If you have questions which remain unanswered by these operating
instructions, contact our technical support service or other technical
personnel.
b) Connected devices
• Also observe the safety and operating instructions of any other de-
vices which are connected to the product.
c) Batteries
• Correct polarity must be observed while inserting the battery.
• The batteries should be removed from the device if it is not used
for a long period of time to avoid damage through leaking. Leaking
or damaged batteries might cause acid burns when in contact with
skin, therefore use suitable protective gloves to handle corrupted
batteries.
• Batteries must be kept out of reach of children. Do not leave batter-
ies lying around, as there is risk, that children or pets swallow them.
• All batteries should be replaced at the same time. Mixing old and
new batteries in the device can lead to battery leakage and device
damage.
• Batteries must not be dismantled, short-circuited or thrown into
re. Never recharge nonrechargeable batteries. There is a risk of
explosion!
Up-to-date Operating Instructions
Download the latest operating instructions at
www.conrad.com/downloads or scan the QR code
shown. Follow the instructions on the website.
Explanation of Symbols
The symbol with the lightning in the triangle is used if
there is a risk to your health, e.g. due to an electric shock.
The symbol with the exclamation mark in the triangle is
used to indicate important information in these operating
instructions. Always read this information carefully.
The arrow symbol indicates special information and
advice on operation.
This product must only be used in dry, enclosed indoor
areas. It must not become damp or wet, as this may result
in a fatal electric shock!
Delivery Content
• Remote wall switch
• Battery 12 V/23 A
• Operating instructions
Operating instructions
Remote Wall Switch, white color
Item no. 1761747
Installation and Connection
The wireless wall switch is only intended for use in
dry indoor locations.
• Carefully lift the front cover of the
wireless wall switch (e.g. with a
screw driver) and remove it (see
picture on the right).
• Remove the mounting plate. The
mounting plate for the wireless wall
switch is xed to the electronic part
of the wireless wall switch with 4
clamps (see picture on the right).
• The mounting plate has two mount-
ing holes (see the picture on the
right). Remove the mounting plate
and mark the mounting holes on
the wall.
• Drill the holes.
• Attach the mounting plate to the wall,
using suitable mounting material.
• Attach the electronic part of the
wireless wall switch to the mounting
plate.
• Insert a 12V-battery (type: 23A) in
the battery compartment of the wire-
less wall switch, paying attention to the correct polarity.
• Attach the front plate to the wireless wall switch.