Instructions
Intended use
This product is used to remotely switch a connected electrical consu-
mer on and off. To do this, a suitable radio transmitter of the RS2W
radio system is necessary. The connected consumer can also be swit-
ched on or off manually using a button at the front.
The product is intended for one load with a maximum power/current
consumption or 3500 W/15.2 A (resistive load) resp. 600 W/2.6 A
(inductive load). Power is supplied by a common household power
socket (230 V/AC, 50 Hz).
It is intended for indoor use only. Do not use it outdoors. Contact with
moisture, e.g. in bathrooms, must be avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or mo-
dify this product. If you use the product for purposes other than those
described above, the product may be damaged. In addition, improper
use can cause hazards such as short circuiting, re, electric shock
etc. Read the instructions carefully and keep them. Make this product
available to third parties only together with its operating instructions.
This product complies with the statutory national and European requi-
rements. All company names and product names are trademarks of
their respective owners. All rights reserved.
Safety instructions
Read the operating instructions carefully and espe-
cially observe the safety information. If you do not fol-
low the safety instructions and information on proper
handling in this manual, we assume no liability for any
resulting personal injury or damage to property. Such
cases will invalidate the warranty/guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may
become dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight,
strong jolts, high humidity, moisture, ammable gases, vapours and
solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of
operation and protect it from any accidental use. Safe operation can
no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions
or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even
from a low height can damage the product.
• Also observe the safety and operating instructions of any other de-
vices which are connected to the product.
• The product is designed in accordance with protection class I. Only
a standard grounding mains socket of the public supply grid may be
used as a power source.
• The mains socket into which the product is plugged must be readily
accessible.
• The radio-controlled switch socket is equipped with a child safety
lock.
Only when the pins of a power plug are placed in both openings of
the socket at the front of the radio-controlled switch socket at the
same time will the mechanism release the opening.
Even so, be especially careful if children are around. Children can-
not realise the danger arising from the incorrect use of electrical
devices. There is a risk of a life-threatening electric shock!
• The product may be used in dry, enclosed indoor areas only; it must
not get damp or wet!
Never position the product in the direct vicinity of a bathtub, shower,
bathroom, swimming pool, or similar. Danger to life from electric
shock!
• Keep the product away from strong magnetic elds occurring near
machines, electric motors or loudspeakers.
• Do not use this product in hospitals or medical institutions. Although
the senders of the RS2W radio systems only emit relatively weak
radio signals, these may lead to the malfunctioning of life-support
systems. The same may also apply to other zones.
• Never touch, operate, plug in or unplug the product with damp or
wet hands. There is a risk of a life-threatening electric shock! The
same applies for the plug of the consumer that is inserted in the
socket of the product.
• Never connect the product to the power supply immediately after it
has been transferred from a cold room into a warm one (e.g., during
transport). Condensation water that forms might destroy the device.
Moreover, there is danger of electric shock!
Allow the device to reach room temperature before switching it on.
Wait until the condensation has evaporated. This might take several
hours. Only after this should the product be plugged in to a mains
socket and put into use.
• Always pull a mains plug out of the radio-controlled switch socket
on the gripping surface. Never unplug a mains plug from a mains
socket by pulling the cable.
Latest operating instructions
Download the latest operating instructions via the
link www.conrad.com/downloads or scan the QR
code shown. Follow the instructions on the website.
Explanation of symbols
The lightning symbol inside a triangle is used when the-
re is a potential risk of personal injury, such as electric
shock.
An exclamation mark in a triangle indicates important ins-
tructions in this operating manual that absolutely have to
be observed.
The arrow symbol indicates specic tips and advice on
operation.
The product is intended for use in dry indoor rooms only;
it must not become damp or wet.
Observe the operating instructions!
Delivery content
• RS2W Radio-controlled switch socket
• Operating instructions
Operating instructions
RS2W Radio-controlled switch socket
Item no. 1761762
• Never overload the product. Observe the maximum connected load
in the chapter “Technical Data”.
• Do not connect in series! This can lead to an overload of the ra-
dio-controlled switch socket! There is a risk of re!
• Do not operate while covered! At higher connected loads, the
radio-controlled switch socket becomes warm, which can lead to
overheating and potentially a re if covered!
• Current-free only when the plug is withdrawn!
• Do not use the product if it is damaged. There is a risk of a
life-threatening electric shock! In this case, dispose of the product in
an environmentally correct manner.
• Always pull the radio-controlled switch socket out of the mains sock-
et (e.g. wall socket) before cleaning it or when the device will not be
in use for a long time (e.g. for storage).
• Never pour any liquids above or next to the product. You run the risk
of causing a re or a fatal electric shock.
If any liquid has still managed to enter the device, immediately turn
off the power supply to the mains socket at which the product is
connected (turn off the fuse / circuit breaker / residual current ope-
rated circuit breaker of the associated circuits). Only then can you
unplug the radio-controlled switch socket from the mains socket and
contact a specialist. Do not use the product anymore.
• Use the product only in a temperate and not in a tropical climate.
• Consult an expert when in doubt about operation, safety or connec-
tion of the device.
• Maintenance, modications and repairs are to be performed exclu-
sively by an expert or at a qualied shop.