Instructions

• Brieypushthebutton“FUNC”toconrm;thehoursofthetimeash.
• Set the hours of the time with the buttons “+/ON” and “-/OFF”. Keep the respective button
pressed for quick adjustment.
• Brieypushthebutton“FUNC”toconrm;theminutesofthetimeash.
• Set the minutes of the time with the buttons “+/ON” and “-/OFF”. Keep the respective button
pressed for quick adjustment.
• Brieypushthebutton“FUNC”toleavesettingmode.
d) Teaching in the receiver for the temperature controller
The receiver has the same build as the radio switching socket of the RS2W systems,
Conrad item no. 1761762). It can be taught to every radio transmitter of the RS2W
radio system.
Before teaching in, observe the operating instructions for the radio transmitter used.
While teaching, maintain a minimum distance of 20 - 30 cm between the transmitter
and the receiver. Otherwise, registration may fail.
• When the receiver (radio switching socket) is on (LED in the operating button lit, connected
consumerisactivated),switchoffthereceiverrst.
• Forthis,brieypushtheoperatingbutton;theLEDintheoperatingbuttonmustgoout.
The receiver (radio switching socket) must be off (LED in the operating button is off);
otherwise, registration cannot be performed.
• Start the registration process on the temperature controller.
• Pushthebutton“FUNC”brieyrepeatedlyuntil“CANCEL”appearsattheleftofthedisplay.
Then keep the button “+/ON” pushed for 2 seconds until the two arrows in the icon “ ”
ashalternatingly.Thenreleasethebutton.
The temperature controller is now ready for registration of the receiver (radio switching
socket).
• Keep the operating button on the receiver (radio switching socket) pushed (approx. 3
seconds) until the two arrows in the symbol “ ” on the temperature controller stop
ashing.
30