Instructions

Add an auto code device
1. Establish the power supply to the end-node
device.
2. Open the gateway dashboard.
3. Touch +.
4. Select Add device from the drop down
menu.
5. Select the device type.
6. Name the edge device.
7. Conrm your settings with
.
8. Conrm the prompt with Cancel.
9. Put your end-node device into learning
mode. Refer to its hardware instructions.
10. On the gateway dashboard touch
next to
the end-node device to start the learning.
11. Conrm the prompt with Ok.
12. Gateway and end-node device are learnt:
- Sensing devices: the prompt closes.
If learning fails,
will show. Repeat the
learning procedure.
- Other devices: the prompt stays open.
Wait at least 3 seconds, then conrm with
Done.
13. Use the app to control the end-node device
to conrm proper functioning.
- If you fail to control the device, repeat the
learning procedure.