Manual

Turn on the power supply.
TheLEDbrieylightsupyellowandthenblue.Youwillheartwobeeps.Thecodelockisnow
in standby mode.
 IftheLEDashesgreenandbluealternatelyduringtheinitialsetup,thedoorcontact
(brown cable, “reed”) is interrupted.
The code lock cannot be programmed in this case.
Close the door so that the door contact is not interrupted. The brown cable (“reed”)
can also be connected to GND/- (black cable). Doing so simulates a closed door.
If button operation is disabled (e.g. start programming mode using the master code,
as described in section 8. a), the light sensor on the back of the code lock is exposed
to light beams. If necessary, attach a non-transparent tape to the light sensor.
LED function description:
LED colour Function
LED lights up blue The code lock is in standby (waiting for tran-
sponder/key input).
LED lights up yellow The programming mode is activated.
LED lights up green The changeover contact is activated.
LED lights up red The code lock is in standby (waiting for tran-
sponder/key input).
The AUX output is activated at the same
time.
LEDashesgreenandbluealternately The door contact is open (operation is disa-
bled during this time).
LEDashesgreenandredalternately The door contact is open (operation is disa-
bled during this time).
The AUX output is activated at the same
time.
50