Operation Manual

52
The home technology brand for the entire house. More information at www.sygonix.com
Use the button “MENU” to return to the respective previous
programming step if desired.
Note:
Incorrect programming of times is automatically preven-
ted so that the switching processes are not confused.
If you have, e.g., set a temperature of 20.0 °C from 06:00
AM onwards in memory slot “P1” and a temperature of
18.0 °C from 9:00 AM onwards in memory slot “P2”, the
memory slot “P3” cannot be programmed to any time
before 09:10 AM.
c) Function G3 “PROGRAM SETBACK”
If you want to change the temperature value of all programmes,
e.g., by 1 °C, you do not need to change the entire programming.
You only need to set a correction value (-3.0 °C......+3.0 °C) in the
function G3 “PROGRAM SETBACK”.
If you then check your temperatures in function G2 “PROGRAM
SETTING”, the value corrected accordingly is displayed there.
Example:
In programme “P1”, the time set is 06:00 AM and the temperature
value is 20.0 °C.
After programming “-1.0 °C” in the function “PROGRAM SETBACK”,
the temperature value in programme “P1” is now 19.0 °C.
If you set “0.0 °C” again in the function”PROGRAM SETBACK”, the
programme “P1” sets a temperature of 20.0 °C again.
Proceed as follows:
1. After selecting this function G3 “PROGRAM SETBACK” and
confi rming with “OK” (2), the temperature correction value
fl ashes in the display.
2. Set the correction value (-3.0 °C......+3.0 °C).with the buttons
“–” (5) and “+” (6).