Manual

TO RECORD A SCRAMBLED/UNSCRAM-
BLED CHANNEL
1. Set the TV/DVD/VHS channel selector to the out-
put channel of tile Cable Converter Box or Satellite
Box. (E×. CH3)
2.Select the channel to record from your Cable
Converter Box or Satellite Box.
Note to CATV system installer:
This reminder is provided to call the CATV sys-
tem installer's attention to Article 82(I-40 of the
NEC that provides guidelines for proper ground-
ing grad, in pallicular, specifies that the cable
ground shall be connected to the grounding sys-
tem of the building as close to tile point of cable
entU as practical.
When you watch a program recorded on gmanother
source (VCR or video camera), use tile audio/video
input jacks oil the front of the TV/DVD/VHS.
Connect the audio/video output jacks of another
source to tile AUDIO L/R gradVIDE() jacks of this
TV/DVD/VHS.
Then press the CHANNEL _,/_" buttons until "AUX"
appears on the screen.
NOTE:
,, When you connect a monaural VCR (mlother
source) to this TV/DVD/VHS, connect tile Audio
output jack of the monaural VCR (another source)
to the AUDIO L jack of this TV/DVD/VHS. The
audio will output in both L and R channel equally.
To the audio
output jacks
[Another source]
(_]_ HEADPHONEVIDEO g AUDIO R
Audio/Video (@[@ @ @
__, coaxial cable _----
:i (not supphed /_
etc. .//
To ;hevideo Q_ ........... :__[TF_/_/ht._S
output jack ............ J
[Fig. 5]
1)()pen the battery compmlment cover by pressing
the cover on the remote unit in the direction of the
afro w.
2)Instal 2 "AA" penlight batteries into the battery
compartment in the direction indicated by the
polarity (+/-) markings.
3)Replace the covel:
Wheu using an external input signal 0mother VCR or
video camera), connect the player's audio/video out-
put cables to the AUDIO L/R IN/
AUX
VIDE() IN jacks of your
TV/DVD/VHS. Theu press the
CHANNEL A or _" button until
"AUX" appears on the screen.
12 EN
IC29