Manual

This function enables you to set a recording length
simply by pressing the REC/OTR button on the
TV/DVD/VHS.
Make sure ...
®TV/DVD/VHS power must be turned oil.
- Insert a cassette tape with its erase prevention tab
in place. (If necessary, rewind or fast forward tile
tape to the point at which you want to begin
recording.)
NOTES:
®This function CANNOT be done from tile remote
control.
- Recording starts immediately when the REC/OTR
button is pressed.
* When tile REC/OTR button is pressed 18 thnes, the
TV/DVD/VHS returns to the Normal Recording
mode.
o To stop the OTR operation, press file STOP button
on the TV/DVD/VHS or on the remote control.
,, To show the remaining time, press the DISPLAY
button on the remote control so that "OTR"
appears oil the TV screen. (It will show up momen-
tarily then disappear.)
,, Recording stops when 0:00 is reached.
®Please note that in the SLP mode maximum record-
ing time, assuming tile tape is started at the begin-
ning, is 8 hours using T-160 (or 6 hours using T-
120).
®If the tape runs out before tile end time, tile
TV/DVD/VHS will switch to tile Stop mode imme-
diately, ejects tile tape and turns itself off.
Press the number buttons on the remote control or
the CHANNEL _, or T button.
Remember: If the TV/DVD/VHS is connected to a
cable box or satellite box, the TV/DVD/VHS must be
on CH3 or CH4, then the chgumel to be recorded is
selected on tile cable box or satellite box.
2 Seect {}_e tap® spe®d
Press tile SPEED button to select the desired tape
speed (SP/SLP).
/
Press tile REC/OTR button on the
TV/DVD/VHS as many times as
needed. Tile recording length will
be determined by the number of _
times you press the REC/OTR button. Each addition-
al push will increase the recording time by 3(I min-
utes. It is set up to 8 hours.
Push(es) Display Recording length
I push (normal recording)
2 pushes (1:30 3(1minutes
3 pushes 1:00 6(I minutes
4, 4, 4,
17 pushes 8:(1(I 48(I minutes
You cgmmake copies of video tapes made by friends
or relatives for your enjoyment.
WARNING: Unauthorized recordings of
copyrighted video tapes may be an
infringement of copyright laws.
Connect your TV/DVD/VHS and a Source (Playing)
VCR using the following diagram.
[Ex: Source (playing)
VCR or camcorder]
Audio/Video
adapter
(not supplied)
VIDEO
©
OUT IN
1)Insert a pro-recorded video cassette into tile Source
(Playing) VCR or camcorder.
2)Insefl a blank video cassette, or one you w_mt to
record over, into the TV/DVD/VHS's cassette com-
pariment.
3)Press the SPEED button on remote contM for the
TV/DVD/VHS to select the desired recording
speed (SP/SLP).
4)Press the CHANNEL A or 'V button on the
TV/DVD/VHS until "AUX" appears on the screen.
5)Press the RECORD button on tile TV/DVD/VHS.
6)Begin playback of the tape in the source (Playing)
VCR or camcoMer.
NOTE: For best results during copying, use the
TV/DVD/VHS's front panel controls whenever pos-
sible. The remote control might affect tile source
(Playing) VCR's playback operation.
31 EN
IC29