Manual

Connections

STB connection using S-VIDEO output to SDTV

NOTE:

S-video cable and audio cable are not included.

Rear panel of STB

COAXIAL

L /

Audio cable

input jacks (L, R)

S-video cablq

To S-video input jack

1 Use a standard antenna cable to connect the wall jack to the ANT IN jack on STB.

2 Use a standard audio cable to connect the audio output jacks (L, R) of STB to the audio input jacks (L, R) on

the TV.

3 Use an S-video cable to connect the S-VIDEO output jack on STB to an S-video input jack on the TV.

4 Set the resolution selection switch to "480i."

5 After completing the connection to the TV. plug the AC power cord of the TV into the AC outlet, then turn

the TV on.

6 Set the TV to the input mode.

NOTE:

Refer to the TV owner's manual for further information.

7 Plug the AC power cord of STB into the AC outlet, then turn STB on.

NOTE:

When using an S-video cable to connect, the resolution of tile video signal output will always be 480i.