Manual

Connections

STB connection using VIDEO output to SDTV

NOTE:

Audio cable and video cable are not included.

Rear panel of STB

Audio cable_ _

audio input jacks (L, R)

To a video input jacks

OUT

Jideo cable

Use a standard antenna cable to connect the wall jack to the ANT. IN jack on STB.

Use a standard audio cable to connect the audio output jacks (L, R) of STB to the audio input jacks (L, R) on

the TV.

NOTE:

It"your TV is monaural (MONO) and has only one audio jack, connect a standard audio cable (white) fi'om

the audio output jack (white) on STB to an audio input jack (white) on the TV. The red cable and jack will

not be used.

3 Use a standard video cable to connect the video output jack on STB to a video input jack on the TV.

4 Set the resolution selection switch to "480i."

5 After completing the connection to the TV. plug the AC power cord of the TV into the AC outlet, then turn

the TV on.

6 Set the TV to the input mode.

NOTE:

Refer to the TV owner's manual for further information.

7 Plug the AC power cord of STB into the AC outlet, then turn STB on.

NOTE:

When using a standard video cable to connect, the resolution of the video signal output will always be 480i.