Manual

Before you start
2345 6 7
15 141312 II
I0
1. POWER button
Press to turn the DVD recorder on and off.
If timer programmings have been set, press to
set the unit in timerostandby mode.
:2. STOP [] button
Press to stop play or recording.
3, REV _ button
Press to skip to the previous chapter or" track,
Press and hold for 1,5 seconds to fast reverse.
4. PLAY_ button
Press to start or" resume play.
5. FWD _l button
Press to skip to the next chapter or track
Press and hold for 1.5 seconds to fast forward,
6. CN T ! A button
Press to change the channel up and down.
7. _ (OPEN/CLOSE) button
Press to open or close the disc tray.
8. Disc tray
Place a disc when open.
9. Display
Refer to "Guide to Displays on the fl'ont panel" on
page [2.
10. Remote control sensor
Receive signals from your remote control so that you
can control the DVD recorder from a distance.
11. REC SPEED button
Press to switch the recording speed,
1:2. REC button
Press to start recording,
13. AUDIO iNPUT jacks (LINE:2)
Use to connect external equipment with standard
audio cables.
14. VIDEO iNPUT jack (LINE2)
Use to connect external equipment with a standard
video cable.
15. SoViDEO iNPUT jack (LINE2)
Use to connect the S-Video output of external equip-
ment with an S-Video cable.
I 2 3 4
II I0 9
6
7
1. AC Power Cord
Connect to a standard AC oudet to supply power to this
unit.
2. AUDIO OUTPUT jacks 1,2
Use to connect aTV monitor;AV receiver or other
equipment with standard audio cables.
3. VIDEO OUTPUT jack
Use to connect aTV monitor, AV receiver or" other
equipment with a standard video cable.
4. SoViDEO OUTPUT jack
Use to connect the S-Video input of aTV monitor, AV
receiver or other equipment with an S-Video cable,
5. COMPONENTVmDEO OUTPUT jacks
Use to connect aTV monitor with component video
inputs with component video cables,
6. TVANTENNA [N jack
7. TVANTENNA OUT iack
Use to connect an antenna cable to pass the signal
fl'om theTV ANTENNA [N to yourTV monitor:
8. SoV[DEO iNPUT jack(LiNE1)
Use to connect the S-Video output of external equip-
ment with an S-Video cable,
9. VmDEO mNPUT jack(UNEl)
Use to connect external equipment with a standard
video cable,
10. AUDmOmNPUTiacks(UNEl)
Use to connect external equipment with standard
audiocables
HH
11. COAXIAL DIGITALAUD[O OUTPUT jack
Use to connect an AV receiver, DoJby Digital decoder
or" other equipment with a coaxial digital input witha
digital coaxial cable.
Use to connect an antenna_
I Do not touch the inner pins of the iacks on the rear panel Electrostatic discharge may cause permanent damage to [
[. the DVD recorder: |
_' This unit does not have the RF modulator. J
7