Safety Instructions

ManualsBrandsSylvania ManualsIndoor FurnishingsEN-ECU-G4-P3D Indoor Furnishings

Page 1 of 4

76-015-DA 10/13

OSRAM and Logo are registered trademarks of OSRAM

GmbH

ENCELIUM and Polaris 3D are registered trademarks of OSRAM SYLVANIA, Inc

GreenBus II are trademarks of OSRAM SYLVANIA, Inc.

SEE THE WORLD IN A NEW LIGHT is a registered trademark of OSRAM SYLVANIA, Inc.

The Energy Control Unit (ECU) is a gateway that

interfaces to both IT equipment (servers, LAN, etc) and

field bus devices (luminaire controllers, sensors, wall

switches, etc). Communication with IT equipment and

other ECUs is achieved using the Ethernet port.

Additionally, two USB 2.0 ports are provided for data

transfer and back-up purposes.

The ECU provides operating power together with

communication signals via GreenBus II

to the various

field bus devices of the system via eight GreenBus II

communication channels.

The ECU makes each device addressable via GreenBus II

(e.g. each light fixture can be individually dimmed and

turned on/off). Devices will obtain their addresses during the commissioning process and no actions are required

during installation.

The following model(s) are available:

Indoor Locations:

EN-ECU-G4-P3D

When using electrical equipment, basic safety precautions should always be followed including the following:

• READ AND FOLLOW ALL SAFETY INSTRUCTIONS.

• Do not let power supply cords touch hot surfaces.

• Do not mount near gas or electric heaters.

• Equipment should be mounted in locations and at heights where it will not readily be subjected to tampering by

unauthorized personnel.

• The use of accessory equipment is not recommended by OSRAM Sylvania as it may cause an unsafe condition.

• Do not use this equipment for other than the intended use.

SAVE THESE INSTRUCTIONS

Important Safeguards

Overview

ENCELIUM

™

Energy Management System

Energy Control Unit

Wiring and Installation Manual

www.sylvania.com/encelium

Summary of content (4 pages)

PAGE 1
www.sylvania.com/encelium ENCELIUM™ Energy Management System Energy Control Unit Wiring and Installation Manual Overview The Energy Control Unit (ECU) is a gateway that interfaces to both IT equipment (servers, LAN, etc) and field bus devices (luminaire controllers, sensors, wall switches, etc). Communication with IT equipment and other ECUs is achieved using the Ethernet port. Additionally, two USB 2.0 ports are provided for data transfer and back-up purposes.
PAGE 2
GreenBus II™ Wiring Communication Circuit (24VDC, Class 2) GreenBus IITM is a low-cost, high reliability communication means to report sensor and wall switch information back to the ENCELIUM Energy Management System and to obtain optimum brightness settings for each individual light fixture from the system – optimized to result in minimum energy costs for any given building.
PAGE 3
Installation Notes The Energy Control Unit shall be installed in dry, indoor locations ONLY. The Energy Control Unit shall be installed into a Pollution Degree 2 (or better) environment. The Energy Control Unit may be installed into a standard 19” rack or mounted to a wall. A bracket is provided for rack installations. Using the screws provided, affix the bracket securely to the Energy Control Unit as shown.
PAGE 4
Regulatory Approvals Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.